Product Specs

Dino6

 

Dino8

The Dino8 is a sediment removal system designed with the small footprint we are known for, and the incredible pumping capacity we always deliver. It all starts with a set of compartmentalized stainless steel floats, that we manufacture in house and pressure check prior to utilizing. We have chosen a cummins turbo diesel to power the Dino8, for performance, reliability, and global support. The power plant turns hydraulic pumps to deliver horsepower to all of the hydraulic circuits as needed. Those circuits include the cutterhead, pump, windlass, and winches. That’s it simple, right? Our cutterheads are manufactured with readily serviceable wear parts. The cutterhead shroud includes porting for water-jetting. The pump is one of our own 8″ submersible hydraulic units designed to work efficiently in a wide variety of materials including sand and cobble. The unit travels back and forth along a 3/8″ cable drive system (windlass pulley drive) allowing an enormous amount of energy to be brought to bear on the work surface and also countering the effect of current, wind, and pipeline pulls. Steady, trackable progress across the job, moving cubic yards per minute. 

 

Submersible Pumps

Dino Pumps are not limited by a suction line which makes them ideally suited for Sewer By-Pass and Sludge Pumping.  Rugged yet lightweight, they are able to handle large amounts of trash, thick viscous sludge and abrasive materials. The Dino Pump is not damaged by rocks or other hard debris and able to pass weeds, pieces of rope and rag type materials.  Using a combination of abrasion resistant steel we cut, cold form, fit and weld our pumps and components in house.

 

Aerator

Two sizes of pumps are available providing the ability to process more than 50,000 or more than 150,000 gallons per hour.

 

Digester Package

Our intent with the digester packages we are offering, is to pair our proven submersible slurry pumps in 6″ or 8″ varieties with a suitably sized power source and the needed hardware and supplies to allow a contractor to procure all of the necessary components in one place, that would allow them to clean out a slurry store or digester. These system are intended to provide a diesel power pack, hoses to supply a hydraulic submersible pump, the pump itself, a hoisting mechanism for the pump, segmented discharge pipeline and hoses, and even a snorkel for filling trucks if necessary. Call to discuss your project.

satisfied customers testimonials

read all testimonials

"Everyone at GeoForm International was very patient and knowledgeable. I researched the Dino6 extensively and had lots of questions that Richard was more than willing to spend time to answer. They were very welcoming when I visited their facility as well."

John Growney - Growney Grading Co